Fleet

How Often Does Each OEM Report Telematics Data? A 2026 Reference by Manufacturer

Update rates range from once a day to every few minutes depending on the OEM. This reference shows measured rates for 29 telematics sources, grouped by how often each one reports.
In short
Telematics update frequency depends on the OEM. Caterpillar, Komatsu and Kobelco report about once a day per machine. Hyundai, Takeuchi and Volvo report a few times a day. John Deere, Hydrema, JLG, Skyjack and many others report hourly or faster. Incus5 is the device-agnostic fleet data intelligence platform that unifies all of them.

How often a machine reports depends far more on the manufacturer than on the machine. This reference lists how often each OEM and telematics provider sends updates, measured from production data in Incus5, so you can plan utilization, location and service reporting around what each source can actually deliver.

How these numbers were measured

The figures come from production data for November 5 to 11, 2026 (7 days), across every Incus5 tenant that uses each source. An OEM's data is mostly the same from one customer to the next. Where it differs, the range is shown.

Updates per day counts the separate readings the OEM sent for one unit in one day. It is the typical (median) unit across all active units, parked ones included. A machine that sits idle reports less, and one that runs all day reports more.

Polling limits what any platform can see

For sources pulled from an API, updates faster than the polling interval cannot be seen. 48 updates a day means a poll every 30 minutes, and 96 means every 15 minutes. At those ceilings the OEM may update more often than the platform samples. Sources marked as a polling limit below should be read as a minimum for the OEM, not its maximum.

Reports about once a day

  • Caterpillar (VisionLink): 1 to 2 updates per unit per day, roughly every 12 to 24 hours. Some units report up to 30.
  • Komatsu (Komtrax): 1 update per day, every 24 hours.
  • Kobelco: 1 update per day, every 24 hours.
  • Otodata tank monitors: 1 update per day, every 24 hours.
  • Bell Equipment: hours, fuel, DEF and payload once a day. Location about 3 times a day (every 8 hours). Running status 20 to 80 times a day.

Reports a few times a day

  • Hyundai (Hi-Mate): location 6 to 7 times a day (every 3 to 4 hours), hours 2 to 3 times a day (every 8 to 12 hours).
  • Takeuchi: location about 7 times a day (every 3 to 4 hours), hours twice a day (every 12 hours).
  • Volvo: 3 to 6 updates a day, every 4 to 8 hours.
  • Navman (Teletrac Navman): about 2 updates a day, every 12 hours.
  • Geoforce: 2 updates a day, every 12 hours.
  • Temeda: 2 updates a day, every 12 hours.

Reports hourly or faster

  • John Deere (Operations Center): 25 to 29 updates a day, about every hour.
  • Hydrema: 27 to 34 updates a day, about every 45 minutes.
  • CNH and New Holland: 69 to 130 updates a day while operating, every 10 to 20 minutes.
  • JLG and SkyTrak (ClearSky): 24 to 45 updates a day, hundreds while operating, every 30 to 60 minutes.
  • Atlas Copco (FleetLink): location 18 times a day, hours 36 times a day, every 30 to 80 minutes. Generator values are reported every 5 minutes.
  • Skyjack (via Trackunit): about 30 updates a day, about every 45 minutes, capped at 48 by the polling limit.
  • Genie (via Trackunit): location 25 times a day, hours 10 times a day, every 1 to 2 hours.
  • Manitou (via Trackunit): 48 updates a day, every 30 minutes (polling limit).
  • Trackunit aftermarket trackers, any make: 1 to 48 updates a day depending on the customer and device, every 30 minutes to 24 hours.
  • Samsara vehicles: 96 updates a day, every 15 minutes (polling limit).
  • Samsara Bluetooth asset tags: about 56 updates a day, about every 25 minutes.
  • OneStep GPS (CalAmp, Digital Matter, Topfly and Xirgo trackers): 48 updates a day, every 30 minutes (polling limit).
  • Solar Technology (Solar-Trak arrow and message boards): location about 290 times a day, hours about 50 times a day, every 5 to 30 minutes.
  • Positioning Universal (PUI) devices: 8 to 12 updates a day typically, every 2 to 3 hours when idle and every few minutes while running.
  • PUI FT200 (via Posiverse): location about 240 times a day, hours about 90 times a day, every 5 to 15 minutes.
  • CoPilot pump controllers (RPM Squared): about 220 updates a day, every 6 to 7 minutes.
  • SignalFire sensors: about 54 sensor updates a day, about every 25 minutes.
  • Vega tank radar: tank level 24 times a day (hourly), other tank details 96 times a day (every 15 minutes).

Fault codes

Diagnostic trouble codes are also captured for Caterpillar, JLG, Atlas Copco, Trackunit-connected units, PUI devices and CoPilot pump controllers.

What this means for a mixed fleet

A fleet with Caterpillar, John Deere and JLG machines gets three very different views of the same day: one reading, about two dozen, and hundreds while running. Utilization, idle time and service triggers calculated from raw feeds are not comparable until the data is normalized. That normalization is what a device-agnostic platform does.

Incus5 is the device-agnostic fleet data intelligence platform that unifies telematics, ERP and operational data. It connects 51+ telematics, OEM and ERP systems. See the integrations directory, the platform overview and the 2026 buyer's guide to rental fleet software.

Measured November 5 to 11, 2026. Last updated November 2026.

Key takeaways

  • Caterpillar, Komatsu, Kobelco and Otodata report about once a day per unit.
  • Hyundai, Takeuchi, Volvo, Navman, Geoforce and Temeda report a few times a day.
  • John Deere, Hydrema, CNH, JLG, Atlas Copco, Skyjack and others report hourly or faster, and some every few minutes.
  • For API sources, the platform polling interval sets the fastest update that can be seen.
  • Mixed fleets need normalized data, because raw update rates differ by more than 100 times between OEMs.

Frequently asked questions

How often does Caterpillar VisionLink report?

Typically 1 to 2 updates per unit per day, roughly every 12 to 24 hours. Some units report up to 30 times a day.

How often does Komatsu Komtrax update?

About once a day per unit, every 24 hours.

Which OEMs report the most often?

CNH and New Holland report every 10 to 20 minutes while operating, Solar Technology every 5 to 30 minutes, and PUI FT200 devices every 5 to 15 minutes.

Does a slower update rate mean the data is worse?

No. It means the OEM sends fewer readings. Daily reporting is enough for hours and service planning, while hourly or faster reporting is better for location and utilization.

Why do some sources show 48 or 96 updates a day?

Those figures are the platform polling limit. 48 updates a day is a poll every 30 minutes and 96 is a poll every 15 minutes. The OEM may update more often than that.

Are fault codes available from every OEM?

No. Fault codes are captured for Caterpillar, JLG, Atlas Copco, Trackunit-connected units, PUI devices and CoPilot pump controllers.

Related Articles

No items found.

Ready to See These Metrics in Action?

Schedule a demo with your data and see how Incus5 tracks all five utilization metrics across your entire fleet.

Schedule a Demo